TEMPERATURE AND IRRADIANCE BASED ANALYSIS THE SPECIFIC VARIATION OF PV MODULE

Authors

  • Mohsin Ali Koondhar Department of Electrical Engineering, Quaid-e-Awam University of Engineering, Science and Technology Nawabshah Pakistan https://orcid.org/0000-0001-6505-6986
  • Irfan Ali Channa Department of Automation, Beijing University of Chemical Technology, Beijing China https://orcid.org/0000-0001-7523-9567
  • Sadullah Chandio Department of Electrical Engineering, Quaid-e-Awam University of Engineering, Science & Technology Nawabshah, Pakistan
  • Muhammad Ismail Jamali Department of Electrical Engineering, Quaid-e-Awam University of Engineering, Science & Technology Nawabshah, Pakistan https://orcid.org/0000-0003-3890-2651
  • Abdul Sami Channa Department of Chemical Engineering, Quaid-e-Awam University of Engineering, Science & Technology Nawabshah, Pakistan https://orcid.org/0000-0002-6663-7261
  • Imtiaz Ali Laghari Department of Electrical Engineering, Quaid-e-Awam University of Engineering, Science and Technology Nawabshah, Pakistan

DOI:

https://doi.org/10.11113/jurnalteknologi.v83.16609

Keywords:

Single diode circuit, irradiance, PV Modules, standard test conditions, temperature

Abstract

The effect of irradiance and increase of temperature on the back surface of the PV module would decrease the standardized efficiency of PV. To overcome this problem observed results of solar module (ORSM) and Newton Raphson’s (iterative) methods have been proposed in this research. This article compares ORSM and iterative methods of changing the specifications of a single diode model (SDM) extracted from a PV module beneath standard test conditions (STC) to calculate irradiance and various operating conditions. To make this comparison, the exact value of each diode parameter on the STC is essential. These are achieved by accepted algebraic values and iterative techniques. Newton Raphson’s technique has been proven to be the mainly precise method to find these specifications in STC. Therefore, these specifications are used to different techniques that change the parameters of an SDM with radiation and temperature. The MATLAB model is designed to assess the conducting of individual techniques by PVM. The results are compared with the measured data, and the accuracy of photovoltaic module efficiency has been achieved through different technologies at different temperature and insolation levels.

Downloads

Published

2021-09-21

Issue

Section

Science and Engineering

How to Cite

TEMPERATURE AND IRRADIANCE BASED ANALYSIS THE SPECIFIC VARIATION OF PV MODULE . (2021). Jurnal Teknologi (Sciences & Engineering), 83(6), 1-17. https://doi.org/10.11113/jurnalteknologi.v83.16609