DEVELOPMENT OF IMAGE RECONSTRUCTION FOR DETECTING STATIC OIL-GAS REGIMES USING INVASIVE ELECTRICAL CAPACITANCE TOMOGRAPHY IN STEEL PIPE APPLICATION – AN INITIAL STUDY An Initial Study

Authors

  • Haziq Syakir Hamzah Faculty of Electrical and Electronics Engineering Technology, Universiti Malaysia Pahang Al-Sultan Abdullah, 26600 Pekan, Pahang, Malaysia
  • Ain Eazriena Che Man Faculty of Electrical and Electronics Engineering Technology, Universiti Malaysia Pahang Al-Sultan Abdullah, 26600 Pekan, Pahang, Malaysia
  • Yasmin Abdul Wahab Faculty of Electrical and Electronics Engineering Technology, Universiti Malaysia Pahang Al-Sultan Abdullah, 26600 Pekan, Pahang, Malaysia https://orcid.org/0000-0003-2652-8623
  • Nurhafizah Abu Talip ᵃFaculty of Electrical and Electronics Engineering Technology, Universiti Malaysia Pahang Al-Sultan Abdullah, 26600 Pekan, Pahang, Malaysia ᵇCenter for Research in Advanced Fluid & Processess (Fluid Centre), Universiti Malaysia Pahang Al-Sultan Abdullah, 26300 Gambang Kuantan, Malaysia https://orcid.org/0000-0001-9762-5119
  • Mohd Mawardi Saari Faculty of Electrical and Electronics Engineering Technology, Universiti Malaysia Pahang Al-Sultan Abdullah, 26600 Pekan, Pahang, Malaysia https://orcid.org/0000-0002-3049-5548

DOI:

https://doi.org/10.11113/jurnalteknologi.v86.20994

Keywords:

ECT, invasive, steel pipe, oil-gas, LBP algorithm

Abstract

Electrical Capacitance Tomography (ECT) is a well-known technique for identifying two-phase regimes when a non-conducting medium is the main medium inside a pipe. However, the common non-invasive techniques of ECT are not suitable for monitoring non-conducting systems that use steel pipes. This is because the placement of the common ECT sensor is outside of the pipe and thus cannot penetrate the conducting pipe. Therefore, this paper presents the development of image reconstruction techniques for invasive Electrical Capacitance Tomography (ECT) in steel pipe applications. The study uses eight electrodes for invasive ECT that are independently designed for easy replacement. The shield guard of each electrode is individually designed, unlike the common sensor of ECT. Moreover, it produces a sensitivity map in the forward problem by modeling the geometry to mimic the real hardware of invasive ECT in Comsol Multiphysics livelink with MATLAB. The data from real hardware is exported offline and a linear back projection algorithm is used as the inverse problem. The phantom of gas-oil with different sizes, positions, and multiple phantoms from the range of 20mm, 25 mm and 33mm are tested. The tomograms of the region of interest can be obtained as a result. The paper concludes that the developed image reconstruction techniques for invasive ECT in steel pipe applications can provide acceptable and reliable results. This study can be useful for researchers and practitioners in the field of ECT and steel pipe applications.

References

J. Sun, W. Yang, and W. Tian. 2015. 3D Imaging based on Fringe Effect of an Electrical Capacitance Tomography Sensor. Measurement: Journal of the International Measurement Confederation. 74: 186-199. Doi: 10.1016/j.measurement.2015.07.018.

H. Wang and W. Yang. 2020. Application of Electrical Capacitance Tomography in Circulating Fluidised Beds – A Review. Applied Thermal Engineering. 176(January): 115311. Doi: 10.1016/j.applthermaleng.2020.115311.

Z. Zeeshan, C. E. Zuccarelli, D. O. Acero, Q. M. Marashdeh, and F. L. Teixeira. 2019. Enhancing Resolution of Electrical Capacitive Sensors for Multiphase Flows by Fine-stepped Electronic Scanning of Synthetic Electrodes. IEEE Transactions on Instrumentation and Measurement. 68(2): 462-473. Doi: 10.1109/TIM.2018.2847918.

U. Hampel et al. 2022. A Review on Fast Tomographic Imaging Techniques and Their Potential Application in Industrial Process Control. Sensors. 22(6). Doi: 10.3390/s22062309.

W. Deabes and K. E. Bouazza. 2021. Efficient Image Reconstruction Algorithm for ECT System Using Local Ensemble Transform Kalman Filter. IEEE Access. 9: 12779-12790. Doi: 10.1109/ACCESS.2021.3051560.

E. J. Mohamad, R. A. Rahim, M. H. F. Rahiman, H. L. M. Ameran, Y. A. Wahab, and O. M. F. Marwah. 2016. Analysis of Crude Palm Oil Composition in a Chemical Process Conveyor using Electrical Capacitance Tomography. Flow Measurement and Instrumentation. 50: 57-64. Doi: 10.1016/j.flowmeasinst.2016.06.011.

N. O. Ali, J. Mohamad-Saleh, Z. A. Aziz, and H. Talib. 2011. Optimization of Electrical Capacitance Tomography Sensor using Design of Experiment method. Jurnal Teknologi. 55(2): 87-99.

E. J. Mohamad, F. R. Mohd Yunus, R. Abdul Rahim, and C. K. Seong. 2011. Hardware Development of Electrical Capacitance Tomography for Imaging a Mixture of Water and Oil. Jurnal Teknologi. 54: 425-442.

R. Abdul Rahim. 2011. Electrical capacitance Tomography: Principles, Techniques and Applications. Penerbit UTM Press,

R. K. Rasel, S. M. Chowdhury, Q. M. Marashdeh, and F. L. Teixeira. 2022. Review of Selected Advances in Electrical Capacitance Volume Tomography for Multiphase Flow Monitoring. Energies. 15(14): 1-22. Doi: 10.3390/en15145285.

H. Herdian, I. Muttakin, A. Saputra, A. Yusuf, W. Widada, and W. P. Taruno. 2016. Hardware Implementation of Linear Back-projection Algorithm for Capacitance Tomography. Proceedings - 2015 4th International Conference on Instrumentation, Communications, Information Technology and Biomedical Engineering, ICICI-BME 2015. 3: 124-129. Doi: 10.1109/ICICI-BME.2015.7401348.

A. E. Che Man et al. 2023. Simulation of Frequency Selection for Invasive Approach of Electrical Capacitance Tomography for Conducting Pipe Application using Oil-gas Regimes. Engineering Technology International Conference (ETIC 2022). 63-68. Doi: 10.1049/icp.2022.2571.

Y. Xu, H. Pu, Y. Li, and H. Wang. 2023. Flow Pattern Identification for Gas-oil Two-phase Flow based on a Virtual Capacitance Tomography Sensor and Numerical Simulation. Flow Measurement and Instrumentation. 92(March). Doi: 10.1016/j.flowmeasinst.2023.102376.

A. Voss, P. Hosseini, M. Pour-Ghaz, M. Vauhkonen, and A. Seppänen. 2019. Three-dimensional Electrical Capacitance Tomography – A Tool for Characterizing Moisture Transport Properties of Cement-based Materialsx. Materials and Design. 181: 107967. Doi: 10.1016/j.matdes.2019.107967.

Y. Abdul Wahab et al. 2018. Forward Problem Solving for Non-Invasive Electrical Resistance. Journal of Tomography System & Sensors Application. 1(1): 1-8.

H. L. M. Ameran et al. 2018. Sensitivity Mapping for Electrical Tomography using Finite Element Method. International Journal of Integrated Engineering. 10(4): 64-67.

W. Deabes, A. Sheta, K. E. Bouazza, and M. Abdelrahman. 2019. Application of Electrical Capacitance Tomography for Imaging Conductive Materials in Industrial Processes. Journal of Sensors. 2019(ii). Doi: 10.1155/2019/4208349.

K. Huang et al. 2019. Effect of Electrode Length of an Electrical Capacitance Tomography Sensor on Gas-Solid Fluidized Bed Measurements. Industrial and Engineering Chemistry Research. 58(47): 21827–21841. Doi: 10.1021/acs.iecr.9b03988.

L. Zhang and M. Zhang. 2021. Image Reconstruction of Electrical Capacitance Tomography based on Optimal Simulated Annealing Algorithm using Orthogonal Test Method. Flow Measurement and Instrumentation. 80(March): 101996. Doi: 10.1016/j.flowmeasinst.2021.101996.

Z. Xia, Z. Cui, Y. Chen, Y. Hu, and H. Wang. 2021. Generative Adversarial Networks for Dual-modality Electrical Tomography in Multi-phase Flow Measurement. Measurement: Journal of the International Measurement Confederation. 173(September 2020): 108608. Doi: 10.1016/j.measurement.2020.108608.

N. A. Abd. Rahman et al. 2018. Image Reconstruction Enhancement using Convolution Back Projection Method for Electrical Tomography Application. International Journal of Integrated Engineering. 10(8): 2018. Doi:10.30880/ijie.2018.10.08.015.

J. Pusppanathan et al. 2017. Single-plane Dual Modality Tomography for Multiphase Flow Imaging by Integrating Electrical Capacitance and Ultrasonic Sensors. IEEE Sensors Journal. 17(19): 1–1. Doi: 10.1109/JSEN.2017.2731867.

I. Bakurov, M. Buzzelli, R. Schettini, M. Castelli, and L. Vanneschi. 2022. Structural similarity index (SSIM) revisited: A data-driven approach. Expert Systems with Applications. 189: 116087. Doi:10.1016/j.eswa.2021.116087.

Downloads

Published

2024-03-27

Issue

Section

Science and Engineering

How to Cite

DEVELOPMENT OF IMAGE RECONSTRUCTION FOR DETECTING STATIC OIL-GAS REGIMES USING INVASIVE ELECTRICAL CAPACITANCE TOMOGRAPHY IN STEEL PIPE APPLICATION – AN INITIAL STUDY An Initial Study. (2024). Jurnal Teknologi, 86(3), 135-143. https://doi.org/10.11113/jurnalteknologi.v86.20994