Power Converter Design for Electric Vehicle Applications

Authors

  • Aree Wangsupphaphol Power Electronics and Drives Research Group, Department of Electrical Power Engineering, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • N. R. N. Idris Power Electronics and Drives Research Group, Department of Electrical Power Engineering, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • A. Jusoh Power Electronics and Drives Research Group, Department of Electrical Power Engineering, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • N. D. Muhamad Power Electronics and Drives Research Group, Department of Electrical Power Engineering, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia

DOI:

https://doi.org/10.11113/jt.v67.2760

Keywords:

Power converter, control design, bi-directional dc to dc converter, supercapacitor, Lithium-ion battery

Abstract

This paper presents the design of a power converter for electric vehicle (EV) applications energized by Li-ion battery (LiB) and supercapacitor (SC). The combination of these energy sources is a good solution for better performances of the EV. A single non-isolated bi-directional converter is proposed in order to get the lowest loss, weight and cost of total electric vehicle applications perspective. The battery voltage represents bus voltage of the power supply system connecting to the load. To control the dynamic of converter, state space averaging technique and power equation linearization are employed to get the transfer function for designing the PI controllers. In order to get the fast response of SC power energizing, the cascade controller is implemented to control current and SC voltage. MATLAB simulation is successfully verified the proposed power converter topology, configuration and controller design for EV. The result shows the capability to settling supply a significant amount of power for step load change within few milliseconds. Sudden load power demand can be drawn from SC. This can reduce the stress of battery as in case of the pure battery power supply system. 

References

M. Ehsani, Y. Gao, and A. Emadi. 2009. Modern Electric, Hybrid Electric, And Fuel Cell Vehicles: Fundamentals, Theory, and Design. CRC Press.

S. Dhameja. 2002. Electric Vehicle Battery Systems. Elsevier Inc.

G. R. Ivan Arsie, Marco Sorrentino. 2006. Hybrid Solar Vehicles: Perspectives, Problems, Management Strategies. Presented at the International Conference on Automotive Technology ICAT06, Istanbul.

J. L. James Larminie. 2003. Electric Vehicle Technology Explained. Hoboken, N. J: Wiley.

M. Prummer, J. Auer, and A. Schneuwly. 2009. Ultracapacitors Drive New Efficiencies for Hybrid Systems Architectures.

P. Thounthong, et al. Energy Management Of Fuel Cell/Battery/Supercapacitor Hybrid Power Source for Vehicle Applications. Journal of Power Sources. 193: 376–385.

P. Thounthong, et al. 2007. Control Strategy of Fuel Cell and Supercapacitors Association for a Distributed Generation System. IEEE Transactions on Industrial Electronics. 54: 3225–3233.

G. T. Samson, et al. 2009. Optimal load sharing strategy in a hybrid power system based on PV/Fuel Cell/ Battery/Supercapacitor. In Clean Electrical PowerInternational Conference on, 2009. 141–146.

S. Pay and Y. Baghzouz. 2003. Effectiveness of Battery-supercapacitor combination in electric vehicles. In Power Tech Conference Proceedings, 2003 IEEE Bologna. 3: 6.

A. Florescu, et al. 2011. Energy Management System for Hybrid Electric Vehicle: Real-time Validation of the VEHLIB Dedicated Library. Chicago, IL.

Lithium-ion battery. Available: http://en.wikipedia.org/wiki/Lithium-ion_battery.

G. Zorpette. 2005. Super charged. Spectrum, IEEE. 42(1): 32–37.

Ultracapacitor-a Dynamic and Efficient Power Storage Device for Automotive. In IQPC 3rd International Congress Advanced Battery Technology.

T. Siang Fui and T. Chee Wei. 2012. A review of Power and Energy Management Strategies in Electric Vehicles. In Intelligent and Advanced Systems (ICIAS), 2012 4th International Conference on. 412–417.

J. Zhang. 2008. Bidirectional DC-DC Power Converter Design Optimization, Modeling and Control. PhD, Electrical Engineering, Virginia Polytechnic Institute and State University.

G. Guidi, et al. 2008. Optimized Power Electronics Interface for Auxiliary Power Buffer Based on Supercapacitors. In Vehicle Power and Propulsion Conference, 2008. VPPC '08. IEEE. 1–6.

M. Ortuzar, et al. 2003. Design, Construction and Performance of a Buck-boost Converter for an Ultracapacitor-based Auxiliary Energy System for Electric Vehicles. In Industrial Electronics Society, 2003. IECON '03. The 29th Annual Conference of the IEEE. 3: 2889–2894.

R. M. Schupbach and J. C. Balda. 2003. Comparing DC-DC Converters for Power Management in Hybrid Electric Vehicles. In Electric Machines and Drives Conference, 2003. IEMDC'03. IEEE International. 3: 1369–1374.

W. JennHwa, et al. 2011. A Parallel Energy-sharing Control for Fuel Cell-battery-ultracapacitor Hybrid Vehicle. In Energy Conversion Congress and Exposition (ECCE), 2011 IEEE. 2923–2929.

M. Jain, et al. 2009. Genetic Algorithm Based Optimal Powertrain Component Sizing and Control Strategy Design for a Fuel Cell Hybrid Electric Bus. In Vehicle Power and Propulsion Conference, 2009. VPPC '09. IEEE. 980–985.

J. Wong. 2012. Parallel Energy Sharing Control For Fuel Cell-Battery-Ultracapacitor Hybrid Electric Vehicle. Master Engineering in Electrical, Faculty of Electrical Engineering, University Technology Malaysia.

J. Moreno, et al. 2006. Energy-management System for a Hybrid Electric Vehicle, Using Ultracapacitors and Neural Networks. Industrial Electronics, IEEE Transactions on. 53: 614–623.

D. M. Robert Warren Erickson. 2001. Fundamentals of Power Electronics.

T. M. U. Ned Mohan, William P. Robbins. 1995. Power Electronics: Converters, Applications, and Design. 2 edition. Wiley.

A. S. Lidozzi, L. 2004. Power Balance Control of Multiple-input DC-DC Power Converter for Hybrid Vehicles. Industrial Electronics, 2004 IEEE International Symposium on. 2: 1467–1472.

H. Fadali. 2008. Fuel Cell Distributed Generation: Power Conditioning, Control and EnergyManagement. Electrical and Computer Engineering, University of Waterloo, Ontario, Canada.

X. Yan. 2000. Control Strategies and Power Electronics in a Low-cost Electric Vehicle Propulsion System Employing a Brushless DC Machine.

L. L. Solero, A.; Pomilio, J. A. 2004. Design of Multiple-input Power Converter for Hybrid Vehicles. Applied Power Electronics Conference and Exposition.

Downloads

Published

2013-03-15

How to Cite

Power Converter Design for Electric Vehicle Applications. (2013). Jurnal Teknologi (Sciences & Engineering), 67(3). https://doi.org/10.11113/jt.v67.2760