The Use of Reflection Mode Ultrasonic Transceiver Sensor in Pipeline Inspection Guage to Monitor Pipeline Internal Corrosion
DOI:
https://doi.org/10.11113/jt.v70.3471Keywords:
Corrosion, pipeline, pipe inspection, ultrasonic, transceiver sensorAbstract
Aging gas transmission pipelines are prone to internal corrosion due to the presence of carbon dioxide and hydrogen sulphide in the natural gas constituents. Commonly, the in-line inspection tool known as Pipeline Inspection Gauge (PIG) is applied to perform the corrosion inspection of the pipeline. This paper describes an ultrasonic instrumentation system for PIG to monitor internal corrosion of pipeline. The system consists of ultrasonic transceiver sensor, ultrasonic driving circuitry and data acquisition system. The hardware is equipped with a sensor carrier which is propelled along the test pipeline. The time of flight (TOF) of the ultrasonic wave is measured and was used to evaluate the internal corrosion of pipeline. An initial experimental instrument was set up to perform the distance measurement test at a frequency of 390 kHz, to simulate the changes of pipe wall thickness due to corrosion effect. Surface anomalies were created at different positions to simulate the changes of pipe wall thickness due to the corrosion effect. Variation in measured distances implied the existence of the surface anomalies. The results of the simulated surface anomalies showed that the percentage error was less than + 5%. The large value of average DC voltage gave indication of distance increment due to the depth of the surface anomalies. The developed ultrasonic instrumentation system is capable to monitor the internal corrosion of pipeline.
References
Carvalho, A. A., J. M. A. Rebello, et al. 2006. MFL Signals and Artificial Neural Networks Applied to Detection and Classification of Pipe Weld Defects. NDT & E International. 39(8): 661–667.
Mohitpour, M., J. Szabo, and T. Van Hardeveld. 2005. Pipeline Operation & Maintenance: A Practical Approach. ASME Press.
Folga, S. M. 2007. Natural Gas Pipeline Technology Overview, Argonne National Laboratory Technical Report ANL/EVS/TM/08-5.
Obanijesu, E.O., V. Pareek, M. O. Tade. 2010. Hydrate Formation and its Influence on Natural Gas Pipeline Internal Corrosion Rate. Society of Petroleum Engineers Conference. 128544-MS.
Bickerstaff, R., M. Vaughn, G. Stoker, M. Hassard, M. Garret. 2002. Review of Sensor Technologies for In-Line Inspection of Natural Gas Pipelines. Pipes and Pipelines International. 48 (1): 25–28.
Bubenik, T. A., J. B. Nestleroth, B. N. Leis. 2000. Introduction to Smart Pigging in Natural Gas Pipelines. Technical Report of the Gas Research Institute GRI-00/0247.
Raj, B., Jayakumar, T., Thavasimuthu, M. 2007. Practical Non-Destructive Testing. 3rd edition. Indira Gandhi Centre for Atomic Research Kalpakkam, India: Alpha Science.
Subramaniam, C. V. 2006. Practical Ultrasonics. Indira Gandhi Centre for Atomic Research Kalpakkam. India: Alpha Science.
Blitz, J. and Simpson, G. (1996), Ultrasonic Methods of Non – Destructive Testing. 1 st edition. University Press, Cambridge, United Kingdom.: Chapman & Hall.
Downloads
Published
Issue
Section
License
Copyright of articles that appear in Jurnal Teknologi belongs exclusively to Penerbit Universiti Teknologi Malaysia (Penerbit UTM Press). This copyright covers the rights to reproduce the article, including reprints, electronic reproductions, or any other reproductions of similar nature.
