Numerical Prediction of Blended Wing Body Aerodynamic Characteristics at Subsonic Speed
DOI:
https://doi.org/10.11113/jt.v71.3722Keywords:
Blended wing body, conventional aircraft, l/d ratio, computational fluid dynamicsAbstract
The need for high performance and green aircraft has brought the blended wing (BWB) aircraft concept to the centre of interest for many researchers. BWB is a type of aircraft characterized by a complex blending geometry between fuselage and wing. Recently, many researches had been performed to unlock its aerodynamic complexity that is still not well understood. In this paper, aerodynamic characteristic of a baseline BWB configuration derived from simple conventional aircraft configuration was analysed using the Reynolds-averaged Navier-Stokes computational fluid dynamics (CFD) solver. The main objectives of this work are to predict the aerodynamic characteristics of the BWB concept at steady flight conditions and at various pitch angles. The results obtained are then compared against a simple conventional aircraft configuration (CAC). The results show that the BWB configuration used has 24% higher L/D ratio than the CAC. The increment to the L/D however is mainly due to lower drag than the improvement in the lift.Â
References
L. Blain. 2014. Blended-Wing Boeing completes first test flight. Retrieved at www.gizmag.com/go/7694/ on May 21, 2014.
M. Cooney. 2014. The flying wing concept aircraft takes flight. Retrieved at www.networkworld.com/community/node/17886 on May 21, 2014.
K. Bradley. 2004. A Sizing Methodology for the Conceptual Design of Blended Wing Body Transports. NASA, Paper No. NASA/CR-2004–21301
R.H. Liebeck. 2004. Design of the Blended-Wing-Body Subsonic Transport. Journal of Aircraft. 41(1): 10–25, doi: 10.2514/1.9084.
D. Roman, J.B. Allen and R.H Liebeck. 2000. Aerodynamic Design Challenges of the Blended Wing Body Subsonic Transport. 18th Applied Aerodynamics Conference. AIAA-2000–4335, doi:10.2514/6.2000-4335.
L. Bolsunovsky, N.P. Buzoverya, B.I. Gurevich, V.E. Denisov, L.M. Duneavsky, O.V. Sonin. A.J. Udzhulu, and J.P. Zhurihin. 2001. Flying Wing – Problems and Decisions. Aircraft Design. 4: 193–219.
T. Ikeda, B. Cees. 2006. Aerodynamic Performance of a Blended Wing Body Configuration Aircraft. International Council of Aeronautical Sciences, ICAS.
N. Qin, A. Navalle, A.L. Moigne, M. Laban, K. Hackett and P. Weinerfelt. 2002. Aerodynamic Studies for Blended Wing Body Aircraft. 9th AIAA/ISSMO Symposium on Mutlidisciplinary Analysis and Optimisation. AIAA.202–5448.
M.B. Carter, D.D. Vicroy and D. Patel. 2009. Blended-Wing-Body Transonic Aerodynamics: Summary of Ground Tests and Sample Results (Invited). The 47th AIAA Aerospace Sciences Meeting including The New Horizons Forum and Aerospace Exposition, AIAA.2009–935.
M. Kanazaki, R. Hanida, T. Nara, M. Shibata, T. Nomura, M. Murayama, and K. Yamamoto. 2013. Challenge of Design Exploration for Small Blended Wing Body using Unstructured Flow Solver. Computers & Fluids. 85: 71–77.
Downloads
Published
Issue
Section
License
Copyright of articles that appear in Jurnal Teknologi belongs exclusively to Penerbit Universiti Teknologi Malaysia (Penerbit UTM Press). This copyright covers the rights to reproduce the article, including reprints, electronic reproductions, or any other reproductions of similar nature.
