Experimental Analysis on the Formation of CO-NO-HC in Swirling Flow Combustion Chamber

Authors

  • Mohamad Shaiful Ashrul Ishak School of Manufacturing Engineering, Universiti Malaysia Perlis, P.O Box 77, Pejabat Pos Besar, 01000 Kangar, Perlis, Malaysia
  • Mohammad Nazri Mohd. Jaafar Department of Aeronautics, Automotive & Ocean Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • Wan Zaidi Wan Omar Centre for Electrical Engineering System, University Technology Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia

DOI:

https://doi.org/10.11113/jt.v72.3909

Keywords:

Combustion, air swirler, swirl strength, CO-NO-HC emission

Abstract

The main purpose of this paper is to evaluate the production of CO-NO-HC emissions while varying the swirl angle of curve vane radial swirler. Swirling flow generates central recirculation region (CRZ) which is necessary for flame stability and enhances fuel air mixing. Therefore designing an appropriate air swirler is a challenge to produce stable, efficient and low emission combustion inside burner system. Four radial curved vane swirlers with 30o, 40o, 50o and 60o vane angles corresponding to swirl numbers of 0.366, 0.630, 0.978 and 1.427 respectively were used in this experiment to measure the vane angles effect on emission production in the combustion chamber. Emission measurements were conducted at 5 axial distances from the burner throat, and at 5 locations along the radius starting the central axis at each section. It was found that at the core near the throat, CO and HC concentrations are low due to high available O2 and high fuel mixing rate producing efficient combustion. This is due to the high shear region created the high swirl flow.

References

Jaafar, M.N.M., Ishak, M.S.A., Saharin, S. 2010. Removal of NOx and CO from a Burner System. Environmental Science and Technology. 44 (8): 3111–3115.

Gupta, A. K., Lilley, D. G. and Syred, N. 1984. Swirl Flows. Abacus Press, Tunbridge Wells, England.

Sloan, D. G., Smith, P. J. and Smoot, L. D. 1986. Modelling of Swirl in Turbulent Flow System. Prog. Energy Combust. Sci. 12: 163–250.

Lefebvre, A. H. 1983. Gas Turbine Combustion. First edition. Hemisphere Publishing Corporation.

Mellor, A. M. 1990. Design of Modern Gas Turbine Combustor. Academic Press.

Mohd Jaafar, M. N., Eldrainy, Y. A., Ahmad, M. F. 2009. Investigation of Radial Swirler Effect on Flow Pattern inside Gas Turbine Combustor. Modern Appl. Sci. 3(5): 21–30.

Yehia, A. E., Hossam, S. A., Khalid, M. S., Mohd Jaafar M. N. 2010. A Multiple Inlet Swirler for Gas Turbine Combustors. Int. J. Mechanical Syst. Sci. Eng. 2(2): 106–109.

Beer, J. M., Chigier, N. A. 1972. Combustion Aerodynamics. Applied Science Publishers Ltd.

Al-Kabie, H. S. 1989. Radial Swirlers for Low Emissions Gas Turbine Combustion. University of Leeds, Dept. of Fuel & Energy: PhD.

Beer, J. M., Chigier, N. A. 1972. Combustion Aerodynamics. Applied Science Publisher, London.

Spiers, H. M. 1977. Technical data on Fuel. 7th. ed. The British National Committee, World Power Conference, London,

British Standard-BS845. 1987. Methods for Assessing Thermal Performance of Boilers for Steam, Hot Water and High Temperature Heat Transfer Fluids, Comprehensive Procedure. British Standard Institution. United Kingdom,

Syred, N. 2006. A Review of Oscillation Mechanisms and the Role of the Precessing Vortex Core (PVC) in Swirl Combustion Systems. Progress in Energy and Combustion Science. 32(2): 93–161.

Liang, H., & Maxworthy, T. 2005. An Experimental Investigation of Swirling Jets. Journal of Fluid Mechanics. 525: 115–159.

Downloads

Published

2015-01-08

How to Cite

Experimental Analysis on the Formation of CO-NO-HC in Swirling Flow Combustion Chamber. (2015). Jurnal Teknologi (Sciences & Engineering), 72(4). https://doi.org/10.11113/jt.v72.3909