THE IMPACT OF REACTOR HEIGHT/DIAMETER (H/D) RATIO ON AEROBIC GRANULAR SLUDGE (AGS) FORMATION IN SEWAGE

Authors

  • Nik Azimatolakma Awang Department of Civil Engineering, Faculty of Engineering University of Malaya, 50603 Kuala Lumpur, Malaysia
  • Md. Ghazaly Shaaban Department of Civil Engineering, Faculty of Engineering University of Malaya, 50603 Kuala Lumpur, Malaysia

DOI:

https://doi.org/10.11113/jt.v77.6990

Keywords:

AGS, height to diameter ratio, sewage

Abstract

Until now, the development of aerobic granules sludge (AGS) has been extensively reported using sequencing batch reactor (SBR) with reactor height/diameter (H/D) ratio of over 10. This is because the formation process of aerobic granules itself is depending upon the flowing trajectory inside reactor indulge by reactor height and superficial air velocity (SUAV). Thus, this study aims to determine effect of reactor H/D ratio on performance of AGS develop in two SBRS with equal working volume and organic loading rate (OLR). The two SBRs namely as SBR1 and SBR2 had a difference in reactor H/D ratio of 11.3 and 4.4, respectively. At an aeration rate of 4 L/min,  SUAV for SBR1 was two time higher than in SBR2, which were 1.33 cm/s and 0.7 cm/s, respectively. Thus, the SBR2 configuration condition seems unfavorable for development of compact aerobic granules. However, it was found that aerobic granules can be developed in both SBRs at an OLR as low as 0.12 kg CODs/m3 d and up to 0.49 kg CODs/m3 d. Mature aerobic granules were successfully developed after 49 and 89 days of formation, for Batch1 AGS and Batch2 AGS, respectively. At stable conditions, the highest CODs removal and SS effluent for Batch1 AGS and Batch2 AGS were more than 80% and below 26 mg/L, respectively. While effluent performance in both reactors was high, analysis on SVI30 indicated that SBR1 produced more sludge than SBR2. Compare to SBR1, at similar settling time of 15 min, SBR2 provide a short settling distance for biomass which was preferable in case of system breakdown due to shock OLR.

References

de Kreuk, M. 2006. Aerobic granular sludge: scaling up a new technology. Ph.D Thesis, Technical University Delft, The Netherlands.

Liu, Y.Q. and Tay, J.H. 2006. Variable aeration in sequencing batch reactor with aerobic granular sludge. Journal of Biotechnology. 124(2): 338–346.

Wagner, J. and da Costa, R. H. R. 2013. Aerobic Granulation in a Sequencing Batch Reactor Using Real Domestic Wastewater. Journal of Environmental Engineering. 139(11): 1391–1396.

Liu, Y. and Tay, J.H. 2002. The essential role of hydrodynamic shear force in the formation of biofilm and granular sludge. Water Research. 36(7): 1653–1665.

Kong, Y., Liu, Y.Q., Tay, J.H., Wong, F.S. and J. Zhu, J. 2009. Aerobic granulation in sequencing batch reactors with different reactor height/diameter ratios. Enzyme and Microbial Technology. 45(5): 379–383.

APHA, 2005. Standard Methods for the Examination of Water and Wastewater, 21st Ed. Washington, DC.: American Public Health Association.

Tay, J. H., Liu, Q. S. and Liu, Y. 2001. The effects of shear force on the formation, structure and metabolism of aerobic granules. Applied Microbiology and Biotechnology. 57(1–2): 227–233.

Liu, Y. and Tay, J.H. 2004. State of the art of biogranulation technology for wastewater treatment. Biotechnology Advances. 22(7): 533–563.

Li, A., Li, X. and Yu, H. 2011. Effect of the food-to-microorganism (F/M) ratio on the formation and size of aerobic sludge granules. Process Biochemistry. 46(12): 2269–2276.

Malaysian Standard (MS1228: 1991) Code of Practice for design and installation of sewerage system. SIRIM,

Zhu, L., Yu, Y., Dai, X., Xu, X. and Qi, H. 2013. Optimization of selective sludge discharge mode for enhancing the stability of aerobic granular sludge process. Chemical Engineering Journal. 217: 442–446.

Muda, k., Aris, A., Razman, M., Ibrahim, Z., Van Loosdrecht, M.C.M., Ahmad, A. and Zaini, M. 2011. The effect of hydraulic retention time on granular sludge biomass in treating textile wastewater. Water Research. 45:4711–4721.

Liu, Y. and Liu, Q.S. 2006. Causes and control of filamentous growth in aerobic granular sludge sequencing batch reactors. Biotechnology Advances. 24(1):115–127.

Adav, S. S., Lee, D. J. and Lai, J. Y. 2009. Aerobic granulation in sequencing batch reactors at different settling times. Bioresource Technology. 100(21): 5359–5361.

Beun, J. J, Hendriks, A., van Loosdrecht, M.C.M., Morgenroth, E., Wilderer, P.A. and Heijnen, J.J. 1999. Aerobic granulation in a sequencing batch reactor. Water Research. 33(10): 2283–2290.

Qin, L., Tay, J. H. and Liu, Y. 2004. Selection pressure is a driving force of aerobic granulation in sequencing batch reactors. Process Biochemistry. 39(5): 579–584.

Liu, X.W., Sheng, G.P. and Yu, H.Q. 2009. Physicochemical characteristics of microbial granules. Biotechnology Advances. 27(6):1061–1070.

Li, Y., Wang, Z. and Liu, Y. 2008. Diffusion of Substrate and oxygen in aerobic granules. In Liu, Y. (ed.) Wastewater purification: Aerobic granulation in sequencing batch reactors. 1st Ed. Taylor & Franchis Group.131–147.

Peyong, Y. N., Zhou, Y. Abdullah, A.Z. and Vadivelu, V. 2012. The effect of organic loading rates and nitrogenous compounds on the aerobic granules developed using low strength wastewater. Biochemical Engineering Journal. 67: 52–59.

Martins, A. M. P., Heijnen, J.J. and van Loosdrecht, M.C.M. 2003. Effect of feeding pattern and storage on the sludge settleability under aerobic conditions. Water Research. 37(11): 2555–2570.

Wang, Q., Du, G. and Chen, J. 2004. Aerobic granular sludge cultivated under the selective pressure as a driving force. Process Biochemistry. 39(5): 557–563.

Downloads

Published

2015-12-29

How to Cite

THE IMPACT OF REACTOR HEIGHT/DIAMETER (H/D) RATIO ON AEROBIC GRANULAR SLUDGE (AGS) FORMATION IN SEWAGE. (2015). Jurnal Teknologi (Sciences & Engineering), 77(32). https://doi.org/10.11113/jt.v77.6990