Ethernet Based Optical Tomography System

Authors

  • Ruzairi Abdul Rahim Process Tomography Research Group (PROTOM), Control & Instrumentation Engineering Department, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, 81310 UTM Skudai, Johor, Malaysia
  • Goh Chiew Loon Process Tomography Research Group (PROTOM), Control & Instrumentation Engineering Department, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, 81310 UTM Skudai, Johor, Malaysia
  • Chan Kok San Process Tomography Research Group (PROTOM), Control & Instrumentation Engineering Department, Faculty of Electrical Engineering, Universiti Teknologi Malaysia, 81310 UTM Skudai, Johor, Malaysia

DOI:

https://doi.org/10.11113/jt.v42.752

Abstract

Optical tomography is one of the methods of process tomography, which is less expensive, has a better dynamic response and is more portable for routine use in process plant than other radiation-based tomographic methods. The main objective of this research is to optimize the performance of the optical sensors by increasing the data transfer rate from hardware to personal computer.

References

Abdul Rahim, R. 1996. A Tomographic Imaging System for Pneumatic Conveyors Using Optical Fibres.

Ph. D. Thesis. Sheffield Hallam University.

Chan, K. S. 2002. Real Time Image Reconstruction for Fan Beam Optical Tomography System. M. Sc.

Thesis. Universiti Teknologi Malaysia.

Ibrahim, S., R. G. Green, K. Dutton, R. Abdul Rahim, K. Evans, and A. Goude. 1999. Optical Fibres For

Process Tomography: A Design Study. 1st World Congress on Industrial Process Tomography. Buxton,

Greater Manchester.

Ibrahim, S. 2000. Measurement of Gas Bubbles in a Vertical Water Column Using Optical Tomography. Ph.

D. Thesis. Sheffield Hallam University.

Pang, J. F. 2004. Real-time Velocity and Mass Flow Rate Measurement Using Infrared Tomography. M. Sc.

Thesis. Universiti Teknologi Malaysia.

Lau, K. H. 2003. Design of a TCP/IP Based General Purpose Embedded Fuzzy Logic Controller System. B.

Sc. Thesis. Universiti Teknologi Malaysia.

Stallings, W. 2000. Data and Computer Communications. United States: Prentice Hall: 592-635.

Bonner, P. 1996. Network Programming with Windows Sockets. United States: Prentice Hall: 128-140.

Ooi, Y. P. 2000. Image Reconstruction Algorithm for Optical Tomography Using Microsoft Visual C++. B.

Sc. Thesis. Universiti Teknologi Malaysia.

Downloads

Issue

Section

Science and Engineering

How to Cite

Ethernet Based Optical Tomography System. (2005). Jurnal Teknologi (Sciences & Engineering), 42(1). https://doi.org/10.11113/jt.v42.752