CFD MODELING OF BINARY MIXTURE HYDRODYNAMICS IN GAS-SOLID PARTICLE FLUIDIZED BED REACTOR SYSTEM

Authors

  • Thanatepon Tangpattanatana Department of Chemical Technology, Faculty of Science, Chulalongkorn University, 254 Phayathai Road, Patumwan, Bangkok 10330, Thailand
  • Veeraya Jiradilok D.A. Research Center Co., Ltd., 122 Moo 2, Thatoom, Srimahaphote, Prachinburi 25140, Thailand
  • Pornpote Piumsomboon Center of Excellence on Petrochemical and Materials Technology, Chulalongkorn University, 254 Phayathai Road, Patumwan, Bangkok 10330, Thailand
  • Benjapon Chalermsinsuwan Center of Excellence on Petrochemical and Materials Technology, Chulalongkorn University, 254 Phayathai Road, Patumwan, Bangkok 10330, Thailand

DOI:

https://doi.org/10.11113/jt.v78.8990

Keywords:

Fluidized bed system, binary mixture, CFD, dispersion coefficient, simulation

Abstract

The objective of this research was to compare the effect of a binary mixture between coal, including 500, 700 and 1000-micron size, and sand, 180-micron size, on the mixing behavior in a fluidized bed system. In addition, suitable computational fluid dynamics drag models were explored, including an EMMS model, Gidaspow model and Wen & Yu model. The simulation results were compared for correctness with real plant information. The EMMS model matched well with the obtained data, This is because the employed model considers the particle cluster effect. The EMMS drag model was then used for further computational fluid dynamics simulation. The levels of mixing between sand and coal were predicted by turbulent dispersion coefficient. These coefficients of coal particle were exhibited in axial and radial direction. The highest turbulent dispersion coefficients were found in the mixture with 500 and 1000 micron coal size for radial and axial directions, respectively. The low axial turbulent dispersion coefficient and high radial turbulent dispersion coefficient were preferred for good hydrodynamics behavior.

References

Chalermsinsuwan, B., Gidaspow, D. and Piumsomboon, P. 2011. Two- And Three-Dimensional CFD Modeling Of Geldart A Particles In A Thin Bubbling Fluidized Bed: Comparison Of Turbulence And Dispersion Coefficients. Chemical Engineering Journal. 171: 301-313.

Chalermsinsuwan, B., Kuchonthara, P. and Piumsomboon, P. 2009. Effect Of Circulating Fluidized Bed Reactor Riser Geometries On Chemical Reaction Rates By Using CFD Simulations. Chemical Engineering and Processing. 48(1): 165-177.

Samruamphianskun, T., Piumsomboon, P. and Chalermsinsuwan, B. 2012. Computation Of System Turbulences And Dispersion Coefficients In Circulating Fluidized Bed Downer Using CFD Simulation. Chemical Engineering Research And Design. 90(12): 2164-2178.

Chalermsinsuwan, B., Boonprasop, S., Nimmanterdwong, P. and Piumsomboon, P. 2014. Revised Fluidization Regime Characterization In High Solid Particle Concentration Circulating Fluidized Bed Reactor. International Journal of Multiphase Flow. 66: 26-37.

Zhansheng, S., Wei, W. and Jinghai, L. 2011. A Bubble-Based EMMS Model For Gas–Solid Bubbling Fluidization. Chemical Engineering Science. 60(22): 5541-5555.

Sahoo, A. and Roy, G. K. 2008. Mixing Characteristics Of Irregular Binaries In A Promoted Gas–Solid Fluidized Bed: A Mathematical Model. The Canadian Journal of Chemical Engineering. 86(1): 53-61.

Norouzi, H. R., Mostoufi, N. and Gharebagh, R. S. 2012. Effect of fines on segregation of binary mixtures in gas–solid fluidized beds. Powder Technology. 225: 7-20.

Lungu, M., Zhou, Y., Wang, J. and Yang, Y. 2015. A CFD Study Of A Bi-Disperse Gas–Solid Fluidized Bed: Effect Of The EMMS Sub Grid Drag Correction. Powder Technology. 280: 154-172.

Zhong, H., Gao, J., Xu, C. and Lan, X. 2012. CFD Modeling The Hydrodynamics Of Binary Particle Mixtures In Bubbling Fluidized Beds: Effect Of Wall Boundary Condition. Powder Technology. 230: 232-240.

Lee, B. E., Tu, J. Y. and Fletcher, C. A. J. 2002. On Numerical Modeling Of Particle–Wall Impaction In Relation To Erosion Prediction: Eulerian Versus Lagrangian Method. Wear. 252(3-4): 179-188.

Upadhyay, M. and Park, J. H. 2015. CFD Simulation Via Conventional Two-Fluid Model Of A Circulating Fluidized Bed Riser: Influence Of Models And Model Parameters On Hydrodynamic Behavior. Powder Technology. 272: 260-268.

Sun, J., Wang, J. and Yang, Y. 2012. CFD Investigation Of Particle Fluctuation Characteristics Of Bidisperse Mixture In A Gas–Solid Fluidized Bed. Chemical Engineering Science. 82: 285-298.

Azizi, S., Hosseini, S. H., Ahmadi, G. and Moraveji, M. 2010. Numerical Simulation Of Particle Segregation In Bubbling Gas-Fluidized Beds. Chemical Engineering and Technology. 33(3): 421-432.

Chao, Z., Wang, Y., Jakobsen, J. P., Fernandino, M. and Jakobsen. H. A. 2010. A Binary Kinetic Theory Of Granular Flow Model For Fluidized Beds. 7th International Conference on Multiphase Flow. ICMF 2010: Tampa. FL USA.

Oke, O., Lettieri, P., Salatino, P., Solimene, R. and Mazzei, L. 2014. Numerical Simulations Of Lateral Solid Mixing In Gas-Fluidized Beds. Chemical Engineering Science. 120: 117-129.

Chalermsinsuwan, B., Piumsomboon, P. and Gidaspow, D. 2009. Kinetic Theory Based Computation Of PSRI Riser: Part I-Estimate Of Mass Transfer Coefficient. Chemical Engineering Science. 64(6): 1195-1211.

Jiradilok, V., Gidaspow, D. and Breault, R. W. 2007. Computation Of Gas And Solid Dispersion Coefficients In Turbulent Risers And Bubbling Beds. Chemical Engineering Science. 62(13): 3397-3409.

FLUENT 6.3 User's Guide. [online]. From: https://www.sharcnet.ca/Software/Fluent6/html/ug/main_pre.htm. [Accessed on 20 September 2015].

Hong, K., Wang, W., Zhou, Q., Wang, J. and Li, J. 2012. An EMMS-based Multi-fluid Model (EFM) For Heterogeneous Gas–Solid Riser Flows: Part I. Formulation Of Structure-Dependent Conservation Equations. Chemical Engineering Science. 75: 376-389.

Zhou, Q. and Wang, J. 2015. CFD Study Of Mixing And Segregation In CFB Risers: Extension Of EMMS Drag Model To Binary Gas–Solid Flow. Chemical Engineering Science. 122: 637-651.

Jiradilok, V., Gidaspow, D., Damronglerd, S., Koves, W. J. and Mostofi. R. 2006. Kinetic Theory Based CFD Simulation Of Turbulent Fluidization Of FCC Particles In A Riser. Chemical Engineering Science. 61(17): 5544-5559.

Jiradilok, V., Gidaspow, D., Breault, R. W., Shadle, L. J., Guenther, C. and Shi, S. 2008. Computation Of Turbulence And Dispersion Of Cork In The NETL Riser. Chemical Engineering Science. 63(8): 2135-2148.

Kashyap, M., Chalermsinsuwan, B. and Gidaspow, D. 2011. Measuring Turbulence In A Circulating Fluidized Bed Using PIV Techniques. Particuology. 9(6): 572-588.

Downloads

Published

2016-06-13

Issue

Section

Science and Engineering

How to Cite

CFD MODELING OF BINARY MIXTURE HYDRODYNAMICS IN GAS-SOLID PARTICLE FLUIDIZED BED REACTOR SYSTEM. (2016). Jurnal Teknologi, 78(6-5). https://doi.org/10.11113/jt.v78.8990