IMPEDANCE MODELLING OF METAMATERIAL STRUCTURE BASED ON DOUBLE QUAD-SQUARE SLOT SPLIT RING RESONATOR (DQSS-SRR) AT 4.6 GHZ
DOI:
https://doi.org/10.11113/jt.v78.9036Keywords:
Impedance modelling, resistance, reactance, split ring resonatorAbstract
This paper represents the impedance modelling of metamaterial structure based on Double Quad-Square Slot Split ring Resonator (DQSS-SRR). The impedance was modelled for DQSS-SRR design structures. This structure simulation works had been done in CST Microwave Studio simulation software while the impedance was modelled by using polynomial type in Matlab for resistance, R, and reactance, X, of the impedance. The modelling of the impedance was based on the length of U-slot arm (Larm) and the width of U-slot arm gap (Wgap) of the DQSS-SRR design structure .The impedances were divided into the certain ranges of length and width for dimensions of DQSS-SRR so that an accurate impedance modelling was produced. The impedance was modelled for the resonant frequency of 4.6 GHz. This DQSS-SRR structure has potential application to improve of pyramidal microwave absorber for certain frequency range.
References
Siso, G., Bonache, J. and Martin, F. 2009. Dual-Band Rat Race Hybrid Coupler Implemented Through Artificial Lines Based on Complementary Split Ring Resonators. Proceeding of IEEE MTT-S International Microwave Symposium (IMS). Boston, USA. 625-628.
Braaten, B. D., Aziz, M. A., Schroeder, M. J. and Li, H. 2010. Meander Open Complementary Split Ring Resonator (MOCSRR) Particles Implemented Using Coplanar Waveguides. Proceeding of IEEE International Conference on Wireless Information Technology and Systems (ICWITS). Honolulu, USA. 1-4.
Munir, A. and Soeka, L. R. G. 2014. Performance Enhancement of Coupled Microstrip Lines Using Split Ring Resonators. Proceeding of International Conference on Electrical Engineering and Computer Science (ICEECS). Denpasar, Indonesia. 385-388.
Horestani, A. K., Withayachumnankul, W., Chahadih, A., Ghaddar, Zehar, A. M., Abbott, D., Akalin, T. and Fumeaux, C. 2014. Bandpass Filters Based on Coupled Split Ring Resonators for Surface Waves on Planar Goubau Lines. Proceeding of International Workshop on IWAT. Sydney, Australia. 57-60.
Harfianto, M. A. Suprayogi and Munir, A. 2015. Incorporation of Square Patch and SRR Metamaterials for Dual-Band Printed Antenna. Proceeding of IEEE International Symp. APS-URSI. Vancouver, Canada.
Pendry, J. B., Holden, A. J. Robbins, D. J. and Stewart, W. J. 1999. Magnetism from Conductors and Enhanced Nonlinear Phenomena. IEEE Trans. Microw. Theory Techn. 47(11): 2075-2081.
Baena, J. D., Bonache, J., Martin, F. et al. 2005. Equivalent-Circuit Models For Split-Ring Resonators And Complementary Split-Ring Resonators Coupled To Planar Transmission Lines. IEEE Trans. Microw. Theory Tech. 53(4): 1451-1461.
Shamonin, M., Shamonina, E. Kalinin, V. and Solymar, L. 2005. Resonant Frequencies of a Split-Ring Resonator: Analytical Solutions and Numerical Simulations. Microwave and Optical Technology Letters. 44(2): 133-136.
Garcia-Garcia, J., Aznar, F., Gil, M., Bonache, J. and Martin, F. 2007. Size Reduction of Srrs for Metamaterial and Left Handes Media Design. PIERS Online. 3(3): 266-269.
Nornikman, H., Malek, F., Soh, P. J. and Azremi, A. A. H. Design a Rice Husk Pyramidal Microwave Absorber with Split Ring Resonator. The Asia-Paci¯c Symposium on AppliedElectromagnetics and Mechanics 2010 (APSAEM 2010).
Ezanuddin, A. A. M., Malek, F. and Soh, P. J. 2010. Investigation of Complementary Split Ring Ring Resonator with Dielectric Ring. Loughborough Antennas and Propagation Conference (LAPC). 297-300.
Downloads
Published
Issue
Section
License
Copyright of articles that appear in Jurnal Teknologi belongs exclusively to Penerbit Universiti Teknologi Malaysia (Penerbit UTM Press). This copyright covers the rights to reproduce the article, including reprints, electronic reproductions, or any other reproductions of similar nature.
