PERMEATION OF BENTONITE SUSPENSIONS THROUGH LOOSE SANDY SOIL

Authors

  • Rowshon Jadid Department of Civil Engineering, Bangladesh University of Engineering and Technology (BUET), Dhaka-1000, Bangladesh
  • Md. Zoynul Abedin Department of Civil Engineering, Bangladesh University of Engineering and Technology (BUET), Dhaka-1000, Bangladesh

DOI:

https://doi.org/10.11113/mjce.v27.15934

Keywords:

Grouting, Permeation, Bentonite suspension, Sandy soil, Permeameter

Abstract

Over the past years, the levee breach flood disaster caused by underseepage has become an alarming problem in Bangladesh. The underseepage phenomenon beneath the earthen embankments may be controlled by treating the underlying granular soil with grout suspensions delivered by permeation (permeation grouting), resulting in a less permeable deposit. Drawing on this physical link, a permeameter was fabricated to investigate the permeation of bentonite suspension through the granular soil medium. The variation of injection time of stopping grout flow, injected grout weight, penetration distance with bentonite fraction for a constant pressure grout injection were studied. The time dependent effluent flow rate variation were also monitored in the laboratory. The experimental results showed that grouting operation worked efficiently for a certain range of bentonite fraction. The individual parameters like injection time, penetration distance, injected grout weight decreased with the increase of bentonite concentration. The effluent flow rate reduction became much prominent as the test proceeded towards the end that justified the effectiveness of permeation. Finally, a grout concentration was proposed considering the cost and other factors like penetration distance, injection time etc. for the sand used in this investigation.

References

Axelsson, M., Gustafson, G., & Fransson, Ã…. (2009). Stop mechanism for cementitious grouts at

different water-to-cement ratios.Tunneling and Underground Space 24:390-397.

Datta, M., & Gulhati, S. (2005). Geotechnical Engineering. India: MacGraw-Hill Education,

pp.549

Dupla, J. C., Canou, J., & Gouvenot, D. (2004). An advanced experimental set-up for studying a

monodirectional groutinjection process. Ground improvement 8(3): 91-99.

Hossain, M. Z., & Sakai, T. (2008). Severity of Flood Embankments in Bangladesh and Its

Remedial.Agricultural Engineering International: the CIGR Ejournal x: 1-9.

Islam, M. Z., Okubo, K., Muramoto, Y., & Morikawa, H. (1994). Experimental Study on

Sedimentation over the Floodplain due to River Embankment Failure. Bull. Disas. Prey. Res.

Inst., Kyoto Univ. 44(380): 69-77.

Khan, Y. A. (2009). Mechanisms and causes of embankment slope failure at Talaimari location

of the Rajshahi City Protection Embankment, Bangladesh.EGU General Assembly, Vienna,

pp.581

Kim, Y. S., & Whittle, A. J. (2009). Particle network model for simulating the filtration of a

microfine cement grout in sand.Journal of Geotechnical and Geoenvironmental Engineering

(2): 224-236.

Landry, E., Lees, D., & Naudts, A. (2000). New developments in permeation grouting: Design

and evaluation.Concrete International 22(8): 47-52.

Schwarz, L. G., & Chirumalla, M. (2007). Effect of injection pressure on permeability and

strength of microfine cement grouted sand. Proceedings of Geo-Denver, Denver, CO, 1-15

Yoon, J. (2011). Application of Pore Fluid Engineering for Improving the Hydraulic

Performance of Granular Soils. Ph.D. Thesis, The University of Texas at Austin.

Downloads

Published

2018-07-09

Issue

Section

Articles

How to Cite

PERMEATION OF BENTONITE SUSPENSIONS THROUGH LOOSE SANDY SOIL. (2018). Malaysian Journal of Civil Engineering, 27(3). https://doi.org/10.11113/mjce.v27.15934