EVALUATION OF SUBGRADE CAPACITY OF JIMMA SOILS USING DCP TEST: A CORRELATION OF CBR AND DCPI

Authors

  • Jemal J. Muhammed Geotechnical Engineering, School of Civil and Environmental Engineering, Jimma Institute of Technology, Jimma University, Jimma, Ethiopia.
  • Murad M. Abdella Highway Engineering, School of Civil and Environmental Engineering, Jimma Institute of Technology, Jimma University, Jimma, Ethiopia

DOI:

https://doi.org/10.11113/mjce.v30.16070

Keywords:

Subgrade capacity, CBR, DCPI, correlation, moisture content, density.

Abstract

Subgrade strength of soils is usually evaluated using California Bearing Ratio (CBR) values. As the cost and time required to conduct CBR test are high, dynamic cone penetrometer (DCP) would be recommended and CBR value can be estimated later from DCP result using a correlation formula. In this paper, laboratory CBR of Jimma fine-grained soils has been correlated with field DCP values referring to the physical properties such as natural moisture content and field density; as these factors significantly influence the behaviour of subgrade soils. Different techniques were used to demonstrate relations that best suit to find values of CBR from DCP test. Equations were developed between CBR and dynamic cone penetrometer index (DCPI) for the total of 36 sample points and adjusted coefficient of determination becomes 0.84. A validation was also done to test the applicability of the developed correlation formula for the local soils with the given physical conditions. The correlation gave a promising relationship between CBR and DCP and can be applicable for preliminary design purpose with the due consideration of the locality circumstances.

References

AASHTO, (2004). Standard specifications for Transportation materials and Methods of Sampling and Testing. American Association of State Highway Officials, USA.

Douglas, C.M. and George, R. C, (2003). Applied Statistics and Probability for Engineers. Third Edition, John Wiley & Sons Inc., USA.

Ehsan, K. (2011). Development and Testing of a Portable In-Situ Near-Surface Soil Characterization System. A PhD dissertation at Northeastern University Boston, Massachusetts.

ERA, (2013). Standard Technical Specifications- Site Investigation Manual. Ethiopian Roads Authority, Ethiopea.

Gebremariam, G. F. and Alemgena, A. A. (2016). Prediction of CBR Using Dcp for Local Subgrade Materials. International Conference on Transport and Road Research, Mombasa, Kenya.

Jemal, J.M. (2014). Indepth Investigation into Engineering Characterstics of Jimma Soils. A thesis Submitted to School of Post Graduate Studies, AAIT, Addis Ababa University.

Kleyn, E., Maree, J., and Savage, P. (1982). The Application of a Portable Pavement Dynamic Cone Penetrometer to Determine In Situ Bearing Properties of Road Pavement Layers and Subgrades in South Africa. Proc. of the Second European Symposium on Penetration Testing, Amsterdam.

Livneh, M. (1987). Validation of Correlation between a Number of Penetration Test and In situ California Bearing Ratio Tests. Transp. Res. Rec. 1219. Transportation Research Board, Washington, D.C., pp. 56-67.

Luo, X., Salgado, R. and Altschaeffi, A. (1998). Dynamic Cone Penetration Test to Assess Mechanical Properties of the Subgrade Soil. Indiana Department of Transportation, Purdue University.

Overseas Road Note 8 (1992). A User Manual for a Program to Analyze Dynamic Cone Penetration Data. Transportation Research Laboratory, UK.

Paige-Green, P and Plessis, L Du (2009). The use and interpretation of the dynamic cone penetrometer (DCP) test. A dissertation submitted to University of Pretoria, SA.

Patel, M. And Patel, H.S. (2012). Experimental Study to Correlate the Test Results of PBT, UCS, and CBR with DCP on Various soils in soaked condition. International Journal of Engineering (IJE), Volume (6) , Issue (5), 244-261.

Sahoo, P. K., and Sudhakar R, K. (2009), Evaluation of Subgrade Soils Using Dynamic Cone Penetrometer. International Journal of Earth Sciences and Engineering, ISSN 0974-5904, Vol. 02, No. 04, pp. 384-388.

Salgado, R. and Yoon, S. (2003). Dynamic Cone Penetration Test (DCPT) for Subgrade Assessment. Indiana Department of Transportation and Federal Highway Administration. Report No. FHWA/IN/JTRP-2002/30.

Wang, J. and Chen, D. (2001). Evaluation of base and subgrade layer moduli using dynamic cone penetrometer. Proceedings of the Eastern Asia Society for Transportation Studies, 3(1).

Webster, S.L., Brown, R.W. and Porter, J.R.( 1994). Force Projection Site Elvaluation Using the Electric Cone Pene tromcter and the Dynamic Cone Penetrometer. Technical Report GL-94- Z7, U.S. Wateirways Experirriental Station, 172 pp.

Wilches, F. J., Diaz, J.J.F. and Avila, J.R.H. (2018). Correlation between California Bearing Ratio (CBR) and Dynamic Cone Penetrometer (DCP) for soil from Sincelejo city in Colombia. International Journal of Applied Engineering Research, ISSN 0973-4562 Vol. 13, No.2 pp. 2068-2071.

Zohrabi, M. and Scott, P.L. (2003). The Correlation between the CBR value and Penetrablity of Pavement Construction Materials. Transportation Research Laboratory, ISSN 0968-4107, pp. 1-18.

Downloads

Published

2018-11-19

Issue

Section

Articles

How to Cite

EVALUATION OF SUBGRADE CAPACITY OF JIMMA SOILS USING DCP TEST: A CORRELATION OF CBR AND DCPI. (2018). Malaysian Journal of Civil Engineering, 30(3). https://doi.org/10.11113/mjce.v30.16070