STRENGTH AND BEHAVIOUR OF LIGHTWEIGHT FERROCEMENTAERATED CONCRETE SANDWICH BLOCKS

Authors

  • Noor Ahmed Memon Faculty of Civil Engineering, Universiti Technologi Malaysia, 81310 Johor Bahru, Johor Malaysia.
  • Salihuddin Radin Sumadi Faculty of Civil Engineering, Universiti Technologi Malaysia, 81310 Johor Bahru, Johor Malaysia.
  • Mahyuddin Ramli School of Housing, Building & Planning, Universiti Sains Malaysia, 11800, Penang, Malaysia

DOI:

https://doi.org/10.11113/mjce.v18.15738

Keywords:

, Sandwich, ferrocement, aerated concrete, lightweight.

Abstract

Results of an experimental investigation on sandwich blocks fabricated using lightweight aerated concrete encased in a ferrocement box are presented in this paper. The primary variables investigated are the type of wire mesh; chicken and square wire mesh, and number of wire mesh layers in the ferrocement box. The response variables considered include compressive strength, overall unit weight and failure mode. The results are compared with control block specimens made solely of the aerated concrete. The results showed significant increases in compressive strength due to the encasement of aerated concrete. Overall, the unit weight of the sandwich blocks comply with the specifications for lightweight structural components. The ferrocement encasement changes the otherwise brittle failure mode of aerated concrete into a ductile one.

References

Abdullah and Takiguchi, K (2003) An investigation into behavior and strength of reinforced concrete columns strengthened with ferrocement jackets. Cement and Concrete Composites,

: 233-242.

ACI Committee 549, (1997) State-of-the-Art report on ferrocement, ACI 549-R97, in manual of concrete practice, ACI, Farmington Hills, Michigan.

Al-Kubaisy, M.A. and Jumaat Z. (2000) Flexural behavior of reinforced concrete slabs with ferrocement tension zone cover. Construction and Building Materials, 14(5): 245-252.

Al-Rifai W.N and Mohammad K.A. (2000) Strength of ferrocement-brick composite columns. Journal of Ferrocement, 30(1):69-83.

Arafa Mohammed and Balaguru, P.N. (2006) Flexural behaviour of high strength-high temperature laminate sandwich beams, Proceedings of Ferro-8, 8th International symposium

and workshop on ferrocement and thin reinforced cement composites, Bangkok, Thailand, pp.189-201.

Arreshvhina, (2002) Application of slag cement based aerated lightweight concrete in non-load bearing wall panels, Masters Thesis, UTM, Malaysia.

El-Debs M.K., Machado, E.F. Jr, De Hanai J.B., and Tekeya. T. (2000) Ferrocement sandwich walls. Journal of Ferrocement, 30(1): 45-58.

Jorg Hohe, L. Librescu and Y.O Sang (2006) Dynamic buckling of flat and curved sandwich panels with transversely compressible core. Composite Structures, 74: 10–24.

Kaushik S.K., Singh K.K., Kumar R. and Sharma T.P. (1996) Performance of ferrocement encased concrete columns under the fire exposure. Journal of Ferrocement, 26(3).

MS1064: Part8: (2001) Guide to modular coordination in buildings: Coordinating sizes and preferred sizes for masonry bricks and blocks, Malaysian standards, department of standards,

Malaysia.

Naaman A.E, (2000) Ferrocement and laminated cementitious composites, Techno press 3000, Ann Arbor, Michigan.

Nanni A. and Chang, W.F. (1986) Ferrocement sandwich panels under bending and edge-wise compression. Journal of Ferrocement, 16(2): 129-140.

Narayanan N. and Ramamurthy, K. (2000) Structure and properties of aerated concrete: A Review, Cement and Concrete Composites, 22: 321-329.

Noor Ahmed M. and Salihuddin R.S. (2006) Ferrocement: A versatile composite structural material. Mehran University Research Journal of Engineering and Technology, 25(1): 9-18.

Noor Ahmed M. Salihuddin R.S. and Mahyuddin R. (2006) Strength and behaviour of aerated concrete encased with ferrocement box, Proceedings of Ferro-8, 8th International

symposium and workshop on ferrocement and thin reinforced cement composites, Bangkok, Thailand, pp.153-164.

Noor Ahmed M., and Salihuddin R. S. (2005) Evolution of cement based composites, Proceedings of the 3rd International Conference on Innovation in Architecture, Engineering

and Construction, Rotterdam, The Netherlands, l: 303-310.

Noor Ahmed M., Salihuddin R.S. and Mahyuddin R. (2005) Flow characteristics of mortar mix for ferrocement, Proceedings of seminar Kebangsaan Penyelidikan Kejuruteraan Awam,

SEPKA 2005, FKA, UTM, Malaysia: 489-497.

Ong K.C.G, Paramasivam, P. and Lim, C.T.E, (1992) Flexural strengthening of reinforced concrete beams using ferrocement laminates. Journal of Ferrocement, 22(4): 331-342.

Tat S. L. and Qian H. C. (2000) Elastic Stiffness Properties and Behaviour of truss-core sandwich panel. Journal of Structural Engineering, 126(5):552-559.

Waliuddin A.M and Rafeeqi S.F.A. (1994) Study of the behaviour of plain concrete confined with ferrocement. Journal of Ferrocement, 24 (2 ): 139-151.

Downloads

Published

2018-05-22

Issue

Section

Articles

How to Cite

STRENGTH AND BEHAVIOUR OF LIGHTWEIGHT FERROCEMENTAERATED CONCRETE SANDWICH BLOCKS. (2018). Malaysian Journal of Civil Engineering, 18(2). https://doi.org/10.11113/mjce.v18.15738