THE EFFECT OF SEA SIDE QUAY WALL ROUGHNESS AND INCLINATION ON BED SCOUR INDUCED BY SHIP BOW-THRUSTERS

Authors

  • Elsayed M. Galal Department of Civil Engineering, Faculty of Engineering, Port Said University, Port Said, Egypt
  • Nezar S. Halabia Department of Civil Engineering, Faculty of Engineering, Port Said University, Port Said, Egypt
  • Ehab R. Tolba Department of Civil Engineering, Faculty of Engineering, Port Said University, Port Said, Egypt

DOI:

https://doi.org/10.11113/mjce.v28.15971

Keywords:

Quay wall, bow-thruster, bed scour, wall roughness, wall inclination

Abstract

In order to increase their transport efficiency, modern ships are built with increasingly larger propellers and bow-thrusters. The combination of larger propellers with greater power and a reduction in bed clearance has created higher levels of bed scour action affecting berthing structures. Therefore, propeller-induced scours need to be considered in the design of quay wall structures. In this study, an experimental investigation was carried out to examine the effect of sea side wall roughness and wall inclination angle on the scouring action induced by bowthruster in front of the quay wall. Two different kinds of sea side quay wall surfaces (glass and concrete) as an indicator of wall roughness and four different sea side wall inclination angles (ï¡ = 90ï‚°, 75ï‚°, 60ï‚°, and 45ï‚°) were considered in this study. The results showed that the eroded area has been decreased with the increase of the sea side wall roughness and inclination

References

Bergh, H., and Cederwall, K. (1981). Propeller erosion in harbours, Hydraulics Laboratory,

Bulletin TRITA-VBI-107, Royal Institute of Technology, Stockholm, Sweden.

Chait, S. (1987) Undermining of quay walls at South African ports due to the use of bowthrusters

and other propeller units, Permanent International Association of Navigation

Congresses, Bulletin 58: 107–110.

Hamill, G.A., Johnston, H.T., Stewart, D.P., (1999) Propeller wash scour near quay walls,

Journal of Waterway, Port, Coastal and Ocean Engineering, 125(4): 170–175.

Hashmi, H. N. (1993) Erosion of a granular bed at a quay wall by a ship’s screw wash, Ph.D.

thesis, The Queen’s University of Belfast, Belfast, U.K.

Hong, J. H., Chiew, Y. M., and Cheng, N. S. (2013) Scour Caused by a Propeller Jet, Journal of

Hydraulic Engineering, 139(9): 1003-1012.

Jurjen de Jong (2014) Numerical modelling of bow thrusters at open quay structures, M.Sc.

Thesis, Delft University of Technology, Delft, Netherlands.

Nielsen, B. (2005) Bow-thruster Induced Damage, a physical model study on bow thruster

induced flow, M.Sc. Thesis, Delft University of Technology, Delft, Netherlands.

Pianc (2015) Guidelines for protecting berthing structures from scour caused by ships, Report

, PIANC, Brussels.

Römisch, K. (2001) Scouring in front of quay walls caused by bow thrusters and new measures

for its reduction, Proceedings 5th Int. Seminar on Renovation and Improvements to existing

Quay Structures, Gdansk, Poland, 1-11.

Qurrain, R.M.M. (1994), "Influence of the sea bed and berth geometry on the hydrodynamics of

the wash from a ship's propeller", Thesis submitted to the Queen's University of Belfast for

the degree of Ph.D. 1994.

Ryan, D., (2002) Methods for determining propeller wash induced scour in harbours, Ph.D.

Thesis, The Queen’s University of Belfast, Belfast, U.K.

Schokking, L.A., Janssen, P.C., Verhagen, H.J. (2003) Bow-thruster induced damage, PIANC

Bulletin, 114: 53-63.

Van Blaaderen, E.A. (2006) Modelling bow thruster induced flow near a quay-wall, M.Sc.

Thesis, Delft University of Technology, Delft, Netherlands.

Van Doorn, R. (2012) Bow Thruster Currents at Open Quay Constructions on Piles, M.Sc.

Thesis, Delft University of Technology, Delft, Netherlands.

Downloads

Published

2018-07-16

Issue

Section

Articles

How to Cite

THE EFFECT OF SEA SIDE QUAY WALL ROUGHNESS AND INCLINATION ON BED SCOUR INDUCED BY SHIP BOW-THRUSTERS. (2018). Malaysian Journal of Civil Engineering, 28(2). https://doi.org/10.11113/mjce.v28.15971