TRIBOLOGICAL EFFECT OF PALM STERIN AND ENGINE OIL (CMEO) ON PURE ALUMINIUM PIN STEEL DISC WITH VARIES SPEED AND CONSTANT LOAD

Authors

  • Aiman Y School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • syahrullail S. School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • S. M. Azhar School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • Ummikalsom A. School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • Kameil A. H. School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia

DOI:

https://doi.org/10.11113/jt.v81.13764

Keywords:

Pin-on disc tribotester machine, coefficient of friction, wear, Tribology, Palm oil

Abstract

Palm stearin has high biodegradability and produces low pollution to the environment. This oil can be improved based on its natural behaviour and can be an alternative to replace the widely used commercial mineral oils. Thus, the negative impact towards the environment can be reduced. This research is to study the performance of two type lubricants which is vegetable oil (Palm Stearin) and commercial mineral engine oil (CMEO). The sample will be tested using pin on disc tribotester machine that follows ASTM G99 standard. The materials used for this experiment are pure aluminium pin (A110) with spherical head and stainless steel disc (SKD11) with four grooves. The experiment will take one hour to finish one test. The conditions that were considered before the beginning of the experiment are constant loads of 1kg, varies sliding speed of 1.5 m/s to 3.5 m/s with incremental 1 m/s and 2.5 ml volume of oil. The wear rate and coefficient of friction can be determined in this experiment. From the result obtained, the coefficient of friction (COF) of palm stearin is 45% higher than CMEO and also the trend for both oils are inversely proportional with sliding speed. Besides that, the wear rate of palm stearin is also bigger than CMEO, which shows that CMEO has better lubrication performance when compared to palm stearin. The additives is needed for palm stearin so that the lubrication performance can compete with the CMEO. From the result also, vegetable oil shows a potential to be a commercial lubricant when the deficiencies can be overcome.

Author Biography

  • Aiman Y, School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
    Department of Thermofluids, School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 Skudai, Johor, Malaysia.

References

Zulhanafi, P., & Syahrullail, S. 2019. The Tribological Performances of Super Olein as Fluid Lubricant Using Four-ball Tribotester. Tribology International. 130: 85-93.

Noorawzi, N., & Samion, S. 2016. Tribological Effects of Vegetable Oil as Alternative Lubricant: A Pin-on-Disk Tribometer and Wear Study. Tribology Transactions. 59(5): 831-837.

Afifah, A. N., Syahrullail, S., & Sidik, N. A. C. 2016. Magnetoviscous Effect and Thermomagnetic Convection of Magnetic Fluid: A Review. Renewable and Sustainable Energy Reviews. 55: 1030-1040.

Shashidhara, Y. M. Ã., & Jayaram, S. R. 2010. Tribology International Vegetable Oils as a Potential Cutting Fluid — An Evolution. Tribiology International. 43(5-6): 1073-1081. doi:10.1016/j.triboint.2009.12.065.

Razak, D. M., Syahrullail, S., Sapawe, N., Azli, Y., & Nuraliza, N. 2015. A New Approach Using Palm Olein, Palm Kernel Oil, and Palm Fatty Acid Distillate as Alternative Biolubricants: Improving Tribology in Metal-on-Metal Contact. Tribology Transactions. 58(3): 511-517.

Golshokouh, I., Syahrullail, S., Ani, F. N., & Masjuki, H. H. 2013. Investigation of Palm Fatty Acid Distillate as an Alternative Lubricant of Petrochemical based Lubricants, Tested at Various Speeds. International Review of Mechanical Engineering. 7(1): 72-80.

Hassan, M., Ani, F. N., & Syahrullail, S. 2016. Tribological Performance of Refined, Bleached and Deodorised Palm Olein Blends Bio-lubricants. Journal of Oil Palm Research. 28(4): 510-519.

Sapawe, N., Samion, S., Zulhanafi, P., Nor Azwadi, C. S., & Hanafi, M. F. 2016. Effect of Addition of Tertiary-Butyl Hydroquinone into Palm Oil to Reduce Wear and Friction Using Four-Ball Tribotester. Tribology Transactions. 59(5): 883-888.

Sidik, N. A. C., Khakbaz, M., Jahanshaloo, L., Samion, S., & Darus, A. N. 2013. Simulation of Forced Convection in a Channel with Nanofluid by the Lattice Boltzmann Method. Nanoscale Research Letters. 8(1): 178.

Riyadh A. Al-Samarai, Haftirman, Khairel Rafezi Ahmad, & Y. Al-Douri. 2012. Effect of Load and Sliding Speed on Wear and Friction of Aluminium- Silicon Casting Alloy. International Journal of Scientific and Research Publications.

Dolan, G. K., Yakubov, G. E., & Stokes, J. R. 2018. Bioâ€Tribology and Bioâ€Lubrication of Plant Cell Walls. Annual Plant Reviews online. 1-42.

Baumgart, P., Canzi, G., Hanashiro, T., Doezema, L. A., & Siniawski, M. T. 2010. Influence of Fatty Acid Additives on the Tribological Performance of Sunfl Ower Oil. (August): 393-403. doi:10.1002/ls.

Saikko, V. 2017. Effect of Contact Area on the Wear of Ultrahigh Molecular Weight Polyethylene in Noncyclic Pin-on-Disk Tests. Tribology International. 114: 84-87.

Baskar, S., Sriram, G., & Arumugam, S. 2015. Experimental Analysis on Tribological Behavior of Nano Based Bio-Lubricants using Four Ball Tribometer. Tribology in Industry. 37(4).

Rani, S., Joy, M. L., & Nair, K. P. 2015. Evaluation of Physiochemical and Tribological Properties of Rice Bran Oil–biodegradable and Potential Base Stoke for Industrial Lubricants. Industrial Crops and Products. 65: 328-333.

Gusain, R., Dhingra, S., & Khatri, O. P. 2016. Fatty-acid-constituted Halogen-free Ionic Liquids as Renewable, Environmentally Friendly, and High-performance Lubricant Additives. Industrial & Engineering Chemistry Research. 55(4): 856-865.

Ing, T. C., Mohammed Rafiq, a. K., Azli, Y., & Syahrullail, S. 2012. The Effect of Temperature on the Tribological Behavior of RBD Palm Stearin. Tribology Transactions. 55(5): 539-548. doi:10.1080/10402004.2012.680176.

States, U. (n.d.). Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus 1. 1-5. doi:10.1520/G0099-05.2.

Zulkifli, N. W. M., Kalam, M. a., Masjuki, H. H., Shahabuddin, M., & Yunus, R. 2013. Wear Prevention Characteristics of a Palm Oil-based TMP (trimethylolpropane) Ester as an Engine Lubricant. Energy. 54: 167-173. doi:10.1016/j.energy.2013.01.038.

Ing, T. C., Rafiq, A. K. M., Azli, Y., & Syahrullail, S. 2012. Tribological Behaviour of Refined Bleached and Deodorized Palm Olein in Different Loads Using a Four-ball Triboteste.

Aiman, Y., & Syahrullail, S. 2017. Development of Palm Oil Blended with Semi Synthetic Oil as a Lubricant Using Four-ball Tribotester. Jurnal Tribologi. 13: 1-20.

Suresha, B., Hemanth, G., Rakesh, A., & Adarsh, K. M. 2019, July. Tribological Behaviour of Pongamia Oil as Lubricant with and without Halloysite Nanotubes Using Four-ball Tester. AIP Conference Proceedings. 2128(1): 030011. AIP Publishing.

Downloads

Published

2019-09-22

Issue

Section

Science and Engineering

How to Cite

TRIBOLOGICAL EFFECT OF PALM STERIN AND ENGINE OIL (CMEO) ON PURE ALUMINIUM PIN STEEL DISC WITH VARIES SPEED AND CONSTANT LOAD. (2019). Jurnal Teknologi (Sciences & Engineering), 81(6). https://doi.org/10.11113/jt.v81.13764