Front-End Circuit in Electrical Resistance Tomography (ERT) for Two-Phase Liquid and Gas Imaging

Authors

  • F. R. Mohd Yunus Process Tomography & Instrumentation Research Group (PROTOM-i), Faculty of Electrical Engineering , Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • R. Abdul Rahim Process Tomography & Instrumentation Research Group (PROTOM-i), Faculty of Electrical Engineering , Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • Suzanna Ridzuan Aw Faculty of Electrical & Automation Engineering Technology, Terengganu Advance Technical Institute University College(TATiUC), Jalan Panchor, Telok Kalong, 24000, Kemaman, Terengganu, Malaysia
  • N. M. Nor Ayob Process Tomography & Instrumentation Research Group (PROTOM-i), Faculty of Electrical Engineering , Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • M. P. Jayasuman Process Tomography & Instrumentation Research Group (PROTOM-i), Faculty of Electrical Engineering , Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia
  • M. F. Jumaah Process Tomography & Instrumentation Research Group (PROTOM-i), Faculty of Electrical Engineering , Universiti Teknologi Malaysia, 81310 UTM Johor Bahru, Johor, Malaysia

DOI:

https://doi.org/10.11113/jt.v70.3462

Keywords:

Electrical resistance tomography, opposite excitation, COMSOL, Howland current pump circuit

Abstract

A steady and precise Voltage Control Current Source (VCCS ) with broad bandwidth plays a very important role in the quality of final images for the Electrical Resistance Tomography (ERT) system. Therefore, a model of current source is proposed in the paper which implement advanced Howland current pump as VCCS. The model are simulated through a software named multisim, and the simulation results show the proposed high-speed operational amplifier (op-amp) LM7171 is capable to produce constant output current at 10 mA (peak) when the frequency changes between 1 kHz to 500 kHz with load varies from 10 Ω to 1 kΩ. A two-dimensional (2D) simulation was performed using COMSOL and the results showed that the model is capable to detect air bubble (radius=10 mm) in a two-phase liquid and gas. The result presented with opposite excitation method with 150 kHz current at 10 mA. The measurement of boundary potentials are significantly influenced by bubble positions particularly towards the boundary. They are hoped to provide useful approaches for the design of practical and low-cost VCCS in ERT system.

References

F. Ferraioli, A. Formisano, and R. Martone. 2005. A Circuital Formulation for Direct Electrical Resistive Tomography Problems. The International Journal for Computation and Mathematics in Electrical and Electronic Engineering. 24: 11.

Jun-Wen Liu and F. Dong. 2004. Electrical Resistance Tomography Based on Single Drive Electrode Method. In Proceedings of the Third International Conference on Machine Learning and Cybernetics, Shanghai. 632–637.

C. Xu and F. Dong. 2011. Application of ERT System Measuring Oil/Water Two-phase Phase Flow Hold-up in Horizontal Pipe. Presented at the 4th International Workshop on Process Tomography, Chengdu China.

A. D. Okonkwo, M. Wang, and B. Azzopardi. Characterisation of a High Concentration Ionic Bubble Column Using Electrical Resistance Tomography. Flow Measurement and Instrumentation.

W. R. Breckon and M. K. Pidcock. 1987. Mathematical Aspects of Impedance Imaging. Clinical Physics and Physiological Measurement. 8: 77–84.

T. J. Yorkey and J. G. Webster. 1987. A Comparison of Impedance Tomographic Reconstruction Algorithms. Clin. Phys. Physiol. Meas. 8: 55–62.

H. Yazdanian, M. M. Samani, and A. Mahanm. 2013. Characteristics of the Howland Current Source for Bioelectric Impedance Measurements Systems. In Biomedical Engineering (ICBME), 2013 20th Iranian Conference on. 189–193.

Z. Li, Z. Xu, C. Ren, W. Wang, D. Zhao, and H. Zhang. 2010. Study of Voltage Control Current Source in Electrical Impedance Tomography System. In Bioinformatics and Biomedical Engineering (iCBBE), 2010 4th International Conference on. 1–4.

M. Rafiei-Naeini and H. McCann. 2008. Low-noise Current Excitation Sub-system for Medical EIT. Physiological Measurement. 29: S173.

L. Jeong Whan, O. Tong In, P. Sang Min, L. Jae Sang, and W. Eung Je. 2003. Precision Constant Current Source for Electrical Impedance Tomography. In Engineering in Medicine and Biology Society, 2003. Proceedings of the 25th Annual International Conference of the IEEE. 2: 1066-1069.

LM7171-Very High Speed, High Output Current, Voltage Feedback Amplifier. T. Instruments, Ed. May 2013 ed: Texas Instruments Inc. 1993.

THS4061-180MHz High Speed Amplifier. T. I. Inc., Ed. December 2003 ed: Texas Instruments Inc. 1998.

OPA604 FET-Input, Low Distortion Operational Amplifier. T. I. Inc., Ed. September 2003 ed: Texas Instruments Inc.

CD4067-CMOS Analog Multiplexer/Demultiplexer. H. Semiconductor, Ed. ed: Texas Instruments Incorporated, June, 2003.

TS5A2066-DUAL-CHANNEL 10-Ω SPST ANALOG SWITCH. T. I. Inc., Ed. April 2010 ed: Texas Instruments Inc. 2005.

M. G. Rasteiro, R. Silva, F. A. P. Garcia, and P. Faia. 2011. Electrical Tomography: A Review of Configurations and Applications to Particulate Processes. KONA Powder and Particle Journal. 29: 67–80.

L. Yi and Y. Wuqiang. 2009. Measurement of Multi-phase Distribution Using An Integrated Dual-modality Sensor. In Imaging Systems and Techniques, 2009. IST '09. IEEE International Workshop on. 335–339.

P. Wang, B. Guo, and N. Li. 2009. Research on ERT System Denoising Technology Excited by Bi-directional Pulse Current. In Control and Automation, 2009. ICCA 2009. IEEE International Conference on. 1262–1265.

Downloads

Published

2014-09-08

How to Cite

Front-End Circuit in Electrical Resistance Tomography (ERT) for Two-Phase Liquid and Gas Imaging. (2014). Jurnal Teknologi, 70(3). https://doi.org/10.11113/jt.v70.3462