Distributed Optical-fibre Strain Sensing in Reinforced Concrete Structures
DOI:
https://doi.org/10.11113/jt.v74.4615Keywords:
Smart structures, monitoring, fibre optics, strain, geotechnical, concrete columns, BOTDRAbstract
An innovative technique based on optical fibre sensing that allows continuous strain measurement has recently been introduced in structural health monitoring. Known as Brillouin Optical Time-Domain Reflectometry (BOTDR), this distributed sensing technique allows measurement of strain along the full length (up to 10 km) of a suitably installed optical fibre. The sensors can be wrapped around or embedded in structures, where a single optical fibre potentially replaces a very large number of point sensors. The installation of optical fibres in concrete structures involved several procedures such as pre-tensioning of cables, spot-glued or end-clamped onto steel rebars, and the use different types of commercially available optical cables. Such instrumentation techniques must be validated in terms of their measurement performance, which is the aim of this research. This was done through a series of well-instrumented uniaxial load tests of concrete columns. The loading of the structures were performed within the elastic range and later loaded up to failure. The test results revealed that all sensing cables of various types used in this study measured strains of about the same values (within the BOTDR accuracy of 30 microstrains) and were comparable with other independent instrumentation devices. Strain data from the two methods of attachment (spot-glued or end-clamped), either pre-tension or without pre-strain, generally did not indicate any dissimilarity between them. These findings have enabled the establishment of the best practice of field instrumentation consisting fibre optic sensors in the current exploration the use of end-clamping technique.
References
H. Ohno, H. Naruse, M. Kihara, and A. Shimada, 2001. Industrial Applications of the BOTDR Optical Fiber Strain Sensor. Opt. Fiber Technol. 7: 45–64.
X. W. Ye, Y. H. Su, and J. P. Han, 2014. Structural Health Monitoring of Civil Infrastructure Using Optical Fiber Sensing Technology: A Comprehensive Review. The Scientific World Journal. 652329: 1–11.
H. Murayama, D. Wada and H. Igawa, 2013. Structural Health Monitoring by Using Fiber-Optic Distributed Strain Sensors With High Spatial Resolution. Photonic Sensors. 3(4): 355–376.
S. Z. Yan and L. S. Chyan. 2010. Performance Enhancement of BOTDR Fiber Optic Sensor For Oil and Gas Pipeline Monitoring. Opt Fiber Technol. 16(2): 100–109.
T. Horiguchi, K. Shimizu, T. Kurashima, M. Tateda, and Y. Koyamada. 1995. Development of a Distributed Sensing Technique Using Brillouin Scattering. J. Lightwave Technol. 13(7): 1296–1302.
H. Mohamad, P. J. Bennett, K. Soga, R. J. Mair, R J and K. Bowers. 2010. Behaviour of an Old Mansonry Tunnel Due to Tunnelling Induced Ground Settlement. Géotechnique. 60(12): 927–938.
H. Mohamad, K. Soga, P. J. Bennett, R.J. Mair, C. S. Lim. 2012. Monitoring Twin Tunnel Interactions Using Distributed Optical Fiber Strain Measurements. J. Geotech. Geoenv. Engng. 138(8): 957–967.
P. J. Bennett, A. Klar, T. E. B. Vorster, C. K., Choy, H. Mohamad, K. Soga, R. J. Mair, P. D. Tester, and R. Fernie. 2006. Distributed Optical Fibre Strains Sensing in Piles. Reuse of Foundation for Urban Sites, Proc. of Int. Conf. Editor A.D. Butcher et al. IHS Press. EP73: 71–78.
H. Mohamad, K. Soga, and B. Amatya. 2014. Thermal Strain Sensing of Concrete Piles Using Brillouin Optical Time Domain Reflectometry. Geotech. Test. J. 37(2): 333–346.
H. Mohamad, K. Soga, A. Pellew, and P. J. Bennett. 2014. Performance Monitoring of a Secant Piled Wall Using Distributed Fiber Optic Strain Sensing. J. Geotech. Geoenv. Engng. 137(12): 1236–1243.
H. Mohamad, K. Soga and P. J. Bennett. 2009. Fibre Optic Installation Techniques for Pile Instrumentation. 2009. Proc. of the 17th Int. Conf. on Soil Mechanics & Geotechnical Engineering. Edited M. Hamza et al., IOS Press. 3: 1873–1876.
A. Klar, P. J. Bennett, K. Soga, et al. 2006. Distributed Strain Measurement for Pile Foundations. Proc. ICE–Geotech. Engng. 159(3): 135–144.
BS EN 1992-1-1:2004 Eurocode 2. 2004. Design of Concrete Structures. General Rules and Rules For Buildings.
H. Mohamad. 2008. Distributed Optical Fibre Strain Sensing of Geotechnical Structures. Phd Thesis. University of Cambridge.
Downloads
Published
Issue
Section
License
Copyright of articles that appear in Jurnal Teknologi belongs exclusively to Penerbit Universiti Teknologi Malaysia (Penerbit UTM Press). This copyright covers the rights to reproduce the article, including reprints, electronic reproductions, or any other reproductions of similar nature.
