AMPLIFICATION AND LASING CHARACTERISTICS OF THULIUM YTTERBIUM CO-DOPED FIBER

Authors

  • M. T. Ahmad Faculty of Electronic and Computer Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
  • A. A. Latiff Photonic Research Centre, University of Malaya, 50603 Kuala Lumpur, Malaysia
  • Z. Zakaria Faculty of Electronic and Computer Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
  • Z. Jusoh Faculty of Electrical Engineering, Universiti Teknologi MARA (UiTM) Terengganu, 23000 Dungun, Malaysia
  • H. Ahmad Photonic Research Centre, University of Malaya, 50603 Kuala Lumpur, Malaysia
  • S. W. Harun Department of Electrical Engineering, Faculty of Engineering, University of Malaya, 50603 Kuala Lumpur, Malaysia

DOI:

https://doi.org/10.11113/jt.v74.4726

Keywords:

Thulium Ytterbium co-doped fiber laser, double-clad fiber, 2 µm laser

Abstract

The amplification and lasing characteristics of the newly developed Thulium-Ytterbium co-doped fiber (TYDF) are investigated. It is obtained that both TYDF amplifier and laser operate at 1950 nm region. The maximum gain of 22.4 dB is obtained for 1942 nm signal when the 980 nm multimode pump power, TYDF length and input signal power are fixed at 1.2 W, 5 m and -20 dBm, respectively. At 5 m long of TYDF, the laser produces two prominent lines at 1960 nm and 1965 nm with peak powers of 2.8 dBm and 3.1 dBm, respectively due to the nonlinear polarization rotation (NPR) effect in the cavity.

References

Saidin, N. 2014. Q-switched Thulium-Doped Fibre Laser Operating at 1900 Nm Using Multi-Walled Carbon Nanotubes Saturable Absorber. The Journal of Engineering. 1(1).

Ahmad, M. 2014. Q-Switched Ultrafast TDFL Using MWCNTs-SA at 2 µm Region. 2014.

Jiang, M. 2013. A Graphene Q-switched Nanosecond Tm-Doped Fiber Laser at 2 μm. Laser Physics Letters. 10(5): 055103.

Ali, S. 2012. Comparison Of Linear And Ring Lasers Of Thulium-Ytterbium Co-Doped Fiber. In Computer and Communication Engineering (ICCCE), 2012 International Conference on. IEEE.

Damanhuri, S. S. A. 2013. Effects of Yb/Tm Concentration and Pump Wavelength on the Performance of Ytterbium-Sensitized Thulium-doped Fiber Laser. Quantum Electronics, IEEE Journal of. 49(1): 95-99.

Jusoh, Z. 2014. Passively Q-switched Thulium Ytterbium co-Doped Fiber Laser Using a Multi-walled Carbon Nanotube Polymer Composite Based Saturable Absorber. 2014.

Zen, D. I. M. 2013. Mode-locked Thulium–Bismuth Codoped Fiber Laser Using Graphene Saturable Absorber in Ring Cavity. Applied Optics. 52: 1226-1229.

Pal, A. 2010. Ytterbium-sensitized Thulium-doped Fiber Laser in the Near-IR with 980 Nm Pumping. Opt. Exp. 18: 5068-5074.

Pan, L. 2007. Passively Q-switched Ytterbium Doped Double-clad Fiber Laser with a Cr4+:YAG Saturable Absorber. IEEE Photon. Technol. Lett. 19: 1979-1981.

Eichhorn, M. 2007. High-pulse-energy Actively Q-Switched Tm3+ -Doped Silica 2 Μm Fiber Laser Pumped at 792 nm. Optics Letters. 32(19): 2780-2782

Ahmad, M. T. 2014. Qâ€switched Thulium-Doped Fiber Laser Operating at 1920 Nm Region with Multiwalled Carbon Nanotubes Embedded in Polyvinyl Alcohol. Microwave and Optical Technology Letters. 56(12): 2817-2819.

Downloads

Published

2015-06-03

Issue

Vol. 74 No. 8: Laser Technology and Optics

Section

Science and Engineering

License

Copyright of articles that appear in Jurnal Teknologi belongs exclusively to Penerbit Universiti Teknologi Malaysia (Penerbit UTM Press). This copyright covers the rights to reproduce the article, including reprints, electronic reproductions, or any other reproductions of similar nature.

How to Cite

AMPLIFICATION AND LASING CHARACTERISTICS OF THULIUM YTTERBIUM CO-DOPED FIBER. (2015). Jurnal Teknologi (Sciences & Engineering), 74(8). https://doi.org/10.11113/jt.v74.4726