SOLIDIFICATION OF WATER TREATMENT SLUDGE (WTS) BY CALCIUM CARBONATE POWDER (CCP)

Authors

  • Nurliyana, I. Universiti Teknologi MARA (UiTM), Selangor, Malaysia
  • Fadzil, M. A. Institute of Infrastructure Engineering & Sustainable Management (IiESM), UiTM, Selangor, Malaysia
  • Saman, H. M. Institute of Infrastructure Engineering & Sustainable Management (IiESM), UiTM, Selangor, Malaysia
  • Hanim, N. K. Universiti Teknologi MARA (UiTM), Selangor, Malaysia
  • Choong, W. K. University of Nottingham, Negeri Sembilan, Malaysia

DOI:

https://doi.org/10.11113/jt.v78.8538

Keywords:

Water treatment sludge (WTS), calcium carbonate powder (CCP), sludge treatment, solidification method, binary blended binder, compressive strength

Abstract

Water treatment sludge (WTS) is a problematic waste produced from water treatment processes. WTS contains high in organic (e.g. nutrients) and inorganic (e.g. heavy metals) pollutants. There are many treatments of sludge. Current treatments of sludge are either by chemical, physical or biological treatments. However, the treatments require high energy level and expensive. Therefore, solidification method is introduced since the production of WTS is increasing. Solidification able to transform the physical forms of the sludge and depends on the type of binder used. In this study, calcium carbonate powder (CCP) was introduced as a binder to solidify WTS. The objectives of this study are to investigate the potential of CCP as binder in solidifying WTS and to obtain the optimum percentage of CCP as cement replacement material to solidify WTS. CCP was used to replace Ordinary Portland Cement (OPC) at 10%, 20%, 30% and 40%. The solidified WTS was cured under water curing for 1, 3, 7 and 28 days. The effectiveness of using CCP as binder to solidify WTS was evaluated based on the compressive strength values.  Results showed that the compressive strength of solidified WTS increased with increasing curing days. However, the compressive strength of solidified WTS was reduced proportionally with the increasing percentage replacement of OPC with CCP. In conclusion, 40% CCP contains in C5 was the optimum CCP replacement percentage. The 28-day compressive strength value of C5 was 0.62 N/mm2 and the value was exceeded the minimum allowable landfill disposal limit which is 0.34 N/mm2. 

References

Lin, C., Zhu, W., and Han, J. 2012. Strength and Leachability of Solidified Sewage Sludge with Different Additives. Journal of Materials in Civil Engineering. 25(11): 1594-1601.

Waijarean, N., Asavapisit, S., and Sombatsompop, K. 2014. Strength And Microstructure Of Water Treatment Residue-Based Geopolymers Containing Heavy Metals. Construction and Building Materials. 50: 486-491.

Gastaldini, A.L.G., Hengen, M.F., Gastaldini, F.D., Amaral, D., Antolini, M.B., and Coletto, T. 2015. The Use of Water Treatment Plant Sludge as a Mineral Addition. Construction and Building Materials. 94: 513-520.

Zhou, Z., Yang, Y., and Li, X. 2015. Effects of Ultrasound Pretreatment on the Characteristic Evolutions of Drinking Water Treatment Sludge and Its Impact on Coagulation Property of Sludge Recycling Process. Ultrasonics Sonochemistry. 27: 62-71.

Xu, G. R., Zou, J. L., and Li, G. B. 2008. Solidification and Leaching Behaviours of Cr6+ in Sludge Ceramsite. Journal of Hazardous Materials. 153: 1031-1035.

Montañés, M. T., Sánchez-Tovar, R., & Roux, M. S. 2014. The Effectiveness of the Stabilization/Solidification Process on the Leachability and Toxicity of the Tannery Sludge Chromium. Journal of Environmental Management. 143: 71-79.

Bayar, S., and Talinli, I. 2013. Solidification/Stabilization of Hazardous Waste Sludge obtained from a Chemical Industry. Clean Technology Environment Policy. 15: 157-165.

Yin, C. Y., Shabuddin, W., Ali, W., and Lim, Y. P. 2008. Oil Palm Ash as Partial Replacement of Cement for Solidification/Stabilization of Nickel Hydroxide Sludge. Journal of Hazardous Materials. 150: 413-418.

Wang, F., Wang, H., Jin, F., and Al-Tabbaa, A. 2015. The Performance of Blended Conventional and Novel Binders in the In-situ Stabilisation/Solidification of a Contaminated Site Soil. Journal of Hazardous Materials. 285: 46-52.

Taha, R. A., Mohamedzein, Y. E. A., Al-Rawas, A. A., and Al-Suleimani, Y. 2010. Solidification of Tank Bottom Sludge. Geotechnical Geology Engineering. 28: 15-25.

Zentar, R., Dongxing, W., Abriak, N.E., Benzerzour, M., and Wenzhao, C. 2012. Utilization of Siliceous-Aluminous Fly Ash and Cement for Solidification of Marine Sediments. Construction and Building Materials. 35: 856-853.

Chindaprasirt, P., Sinsiri, T., Napia, C., and Jaturapitakkul, C. 2013. Solidification of Heavy Metal Sludge using Cement, Fly Ash and Silica Fume. Indian Journal of Engineering & Material Sciences. 20: 405-414.

Radzi Bin, F., Omar, M., Hasnain Isa, M., Rahman, S., Kutty, M., and Malakahmad, A. 2008. Solidification/Stabilization of Waste Activated Sludge from Petroleum Refinery. International Conference on Environment.

Jain, N. 2011. Solidification and Leachability of Cr (VI) in Rice Husk Ash-Blended Cement. International Scholarly Research Network ISRN Civil Engineering.

Siad, H., Alyousif, A., Keskin, O. K., Keskin, S. B., Lachemi, M., Sahmaran, M., and Anwar Hossain, K. M. 2015. Influence of Limestone Powder on Mechanical, Physical and Self-healing Behavior of Engineered Cementitious Composites. Construction and Building Materials. 99: 1-10.

Shaikh, F. U. A., and Supit, S. A. 2014. Mechanical and Durability Properties of High Volume Fly Ash (HVFA) Concrete containing Calcium Carbonate (CaCO3) Nanoparticles. Construction and Building Materials. 70: 309-321.

De Weerdt, K., Kjellsen, K. O., Sellevold, E., and Justnes, H. 2011. Synergy between Fly Ash and Limestone Powder in Ternary Cements. Cement and Concrete Composites. 33(1): 30-38.

De Weerdt, K., Haha, M. Ben, Le Saout, G., Kjellsen, K. O., Justnes, H., and Lothenbach, B. 2011. Hydration Mechanisms of Ternary Portland Cements containing Limestone Powder and Fly Ash. Cement and Concrete Research. 41(3): 279-291.

Archaya, P. K., and Patro, S. K. 2015. Effect of Lime and Ferrochrome Ash (FA) as Partial Replacement of Cement on Strength. Ultrasonic Pulse Velocity and Permeability of Concrete. Construction and Building Materials. 94: 448- 457.

Lan, Y., Jie, W., Zhongyuan, L., Jianli, W., and Dongtian, W. 2015. Material Prepared from Drinking Waterworks Sludge as Adsorbent for Ammonium Removal from Wastewater. Applied Surface Science. 330: 228-236.

Yue, L., Xiongfei, L., Junjie, Y., and Miaoke, W. 2012. Toughness Improvement of Epoxy Resin Mortar by Incorporation of Ground Calcium Carbonate. Construction and Building Materials. 100: 122-128.

Kawashima, S., Hou, P., Corr, D.J., and Shah, S.P. 2013. Modification of Cement-based Materials with Nanoparticles. Cement Concrete Composite. 36: 8-15.

Schöler, A., Lothenbach, B., Winnefeld, F., and Zajac, M. 2015. Hydration of Quaternary Portland Cement Blends containing Blast-Furnace Slag, Siliceous Fly Ash and Limestone Powder. Cement & Concrete Composites. 55: 374-382.

Downloads

Published

2016-05-09

Issue

Section

Science and Engineering

How to Cite

SOLIDIFICATION OF WATER TREATMENT SLUDGE (WTS) BY CALCIUM CARBONATE POWDER (CCP). (2016). Jurnal Teknologi (Sciences & Engineering), 78(5-4). https://doi.org/10.11113/jt.v78.8538